Complexity Explorer Santa Few Institute

Nonlinear Dynamics: Mathematical and Computational Approaches (Fall 2015)

Lead instructor:

This course is no longer in session.

3.4 Nonlinearity and nonintegrability » Homework

Quiz scores are NOT recorded.

  • You may come back to quizzes and take them as many times as you like
  • When you are finished, clicking the "Score" button at the bottom of the test will show you the correct responses.

Instructions

Homework problems in this course are broken into three types and marked by the following symbols:

-- Mandatory problems that should be accessible to all students.

-- Optional problems that are somewhat harder.  We strongly suggest that you work through these problems; completing them will give you greater insight into the topics at hand.  Please discuss them and their results on the forum.

-- Challenging problems that are intended for experts. These are optional; not all students will be able to complete them. Again, feel free to discuss them on the forum.

 

In this homework, you'll explore the damped, sinusoidally driven pendulum -- the one in the movie in segment 3.1.  This system is governed by the following system of ODEs:

\dot{\theta}=\omega \\ \dot{\omega}=\frac{-\beta}{mL}\omega-\frac{g}{L}\sin{\theta}-\frac{A}{mL}\sin{\Omega t}

In these equations, Θ is angular position, ω is angular velocity, m is mass,  L is pendulum length, g is acceleration due to gravity, β is the drag coefficient, A is the (drive) amplitude and Ω is the (drive) frequency.  In the driven pendulum in the movie, the amplitude was fixed by the cam follower design and the frequency was controlled by the actuator that drove the motor, but in this problem you'll vary both of those parameters.  For simplicity, we will assume that m = L = 1, which makes the equations look like this:

\dot{\theta}=\omega \\ \dot{\omega}=-\beta\omega-g\sin{\theta}-A\sin{\Omega t}

Now point your browswer to:

http://tuvalu.santafe.edu/~jgarland/pendulum.html

To use this application, which simulates the equations above, you need to set the parameter values and initial conditions in the text fields located in the bottom-right panel, then click "Setup". This should be done any time you change the text field values.

To begin the simulation after doing that setup, either click "Start Animation", which will generate a trajectory one step at a time, or click "Generate Full Trajectory", which will generate an n-point-long trajectory, where n is the "Max Trajectory Length" input.

The "Time" panel (bottom left) shows time-series plots of Θ (angular position, shown in yellow) and ω (angular velocity, shown in blue).  The "Phase" panel (top right) shows a state-space portrait, with ω on the y-axis and Θ on the x-axis.